How To Install And Program The Faac 7pcb452 455 Control Board In Italian _TOP_
How to Install and Program the Faac 7pcb452 455 Control Board in Italian
How to Install and Program the Faac 7pcb452 455 Control Board in Italian
If you are looking for a reliable and versatile control board for your gate automation system, you might want to consider the Faac 7pcb452 455 Pdf Italiano 67. This control board is compatible with various Faac operators and accessories, and it allows you to customize the operation of your gate according to your needs and preferences. In this article, we will show you how to install and program the Faac 7pcb452 455 control board in Italian, using the Pdf manual that you can download from the Faac website.
Installation of the Faac 7pcb452 455 Control Board
Before installing the Faac 7pcb452 455 control board, make sure that you have all the necessary tools and components, such as a screwdriver, a wire stripper, a multimeter, a differential thermal breaker, a differential switch, an indicator light, a warning sign, and safety devices (such as photocells and limit switches). Also, make sure that the power supply is turned off and that the earthing system is properly constructed.
To install the Faac 7pcb452 455 control board, follow these steps:
Open the control board enclosure by unscrewing the four screws on the front panel.
Mount the control board on the DIN rail inside the enclosure using the hooks on the back of the board.
Connect the power supply cables (230V AC) to the terminal board J4 (L1 and N).
Connect the operator cables to the terminal board J3 (M1 and M2) according to the wiring diagram of your operator model.
Connect the accessories (such as push-buttons, photocells, indicator light, etc.) to the terminal board J1 according to their functions and polarities.
Connect the limit switches and/or gatecoder (if present) to the terminal board J6 according to their functions and polarities.
Connect the rapid connector J2 to an external receiver (such as Minidec, Decoder or RP) if you want to use remote controls for your gate.
Close the control board enclosure by screwing back the four screws on the front panel.
For more details and illustrations on how to install the Faac 7pcb452 455 control board, refer to pages 3-6 of the Pdf manual.
Programming of the Faac 7pcb452 455 Control Board
After installing the Faac 7pcb452 455 control board, you need to program it to set up the operation of your gate. The programming of the control board is divided into two parts: basic programming and advanced programming. Basic programming allows you to set up the main functions of your gate, such as opening time, closing time, partial opening, automatic closing, etc. Advanced programming allows you to fine-tune some parameters of your gate operation, such as force adjustment, pre-flashing time, pause time, etc.
To program the Faac 7pcb452 455 control board, follow these steps:
Turn on the power supply and wait for about 10 seconds for the control board to initialize.
To enter basic programming mode, press and hold both buttons S1 and S2 on the front panel until LED L1 flashes green.
To select a function to program, press button S1 until LED L1 flashes green according to the function number (see table below).
To change the value of a function, press button S2 until LED L2 flashes red according to the value number (see table below).
To confirm a value for a function, press both buttons S1 and S2 until LED L1 flashes green twice.
To exit basic programming mode, press both buttons S1 and S2 until LED L1 turns off.
The following table shows the functions and values that you can program in basic programming mode:
FunctionDescriptionValues
04f6b60f66